Hisense BBCD-535WY Manuel D'instructions Utilisateur page 9

9
Installing the water lines and filter
Installing the water filter
To fit the water filter
installing steps below.
First, take out the water filter and
water lines from the fridge door rack.
Second, determine the location to
mount the external filter. (Note: The
water filter should be mount on the
wall where it is convenient to be
replaced, and do not mount on the
wall behind the refrigerator.)
Third, determine the distance
between the filter and the tap, and the
distance from the filter to the fridge.
Prepare lines as required lengths.
(Cut the proper lengths of water lines
which you determine to connect with
the filter inlet or outlet.)
Fourth, mount the filter holder onto
the wall by using a screwdriver and
attach the water filter.
Filter Holder
Filter Holder
, follow the
Screw
Outlet
Filter
Inlet
Note!
The water lines must be fully
inserted into the filter to prevent water
leaking.
The line length should be less than
5m. If the water line is too long(>5m),
the ice and cold water content may be
affected due to insufficient water
pressure.
Cut the water line as required length
and avoid overbending the water
lines.
It is recommended to have a
suitably qualified person to install the
product.
Warning!
The water filter must be held upright
as shown in the figure above. It is
critical to connect the water inlet and
outlet hoses on the filter correctly.
Never mount the filter onto the
refrigerator. Coolant pipes might be
pierced.
Installing the water lines of
To install the water lines of the filter
follow the instructions of installing
steps below that referring to the
figures supplied.
First, take the 2 clips out, then pull out
the 2 stopper of the water filter.
Stopper
Water Filter
the filter
Clip
Stopper
,