Hisense BBCD-535WY Manuel D'instructions Utilisateur page 26

The motor runs
continuously
A layer of frost
occurs in the
compartment
Temperature
inside is too warm
Temperature
inside is too cold
Doors can't be
closed easily
Water drips on
the floor
The light is not
working
Ice is not
dispensing
It is normal to frequently hear the sound of the motor, it will need to
run more during following circumstances:
Temperature setting is set colder than necessary.
Large quantity of warm food has recently been stored within the
appliance.
The temperature outside the appliance is too high.
Doors are kept open too long or too often.
After your installing the appliance or it has been switched off for a
long time.
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation. Ensure
the door can be fully closed. T o remove the frost, please refer to the
cleaning and care chapter.
You may have left the doors open too long or too frequently; or the
doors are kept open by some obstacle; or the appliance is located
with insufficient clearance at the sides, back and top.
Increase the temperature by following the"Display controls" chapter.
Check whether the top of the refrigerator is tilted back by 10-15mm
to allow the doors to self close, or if something inside is preventing
the doors from closing.
The water pan (located at the rear bottom of the cabinet) may not
be properly leveled, or the draining spout underneath the top of the
compressor depot may not be properly positioned to direct water
into this pan, or the water spout is blocked, or the water is not fully
inserted into the connector. You may need to pull the refrigerator
away from the wall to check the pan and spout and connector.
The LED light may be damaged. Refer to replace LED lights in
cleaning and care chapter.
The control system has disabled the lights due to the door being
kept open too long, close and reopen the door to reactivate the
lights.
Did you wait for 4 hours after installation of the water supply line
before making ice? if it is not sufficiently cool, it may take longer to
make ice, such as when first installed.
Is the water line connected and the water valve open?
Did you manually stop the ice making function? Make sure you
have set the Cubed or Crushed mode on.
Is there any ice blocked within the ice maker bucket or ice chute?
Is the freezer temperature too warm? Try setting the freezer
temperature lower.
26