Hisense BBCD-535WY Manuel D'instructions Utilisateur page 10

Second, fully insert the water lines
into the Inlet and Outlet of the water
filter.
Water line
Water Filter
Inlet
insert the 2 clips in the proper
Third,
position as the figure shown below,
and confirm that each clip holds the
water line firmly.
FLOW
Water line
Connecting the filter inlet line to
the water supplier
Screw the adaptor firmly onto a
suitable 3/4" BSP connector water
outlet. Fully insert the water line into
the plastic adaptor. Then insert the
clip in the install pack as the figure
shown below.
Water valve
Connector
Water line
Outlet
Clip
Water line
Clip
Filter inlet line
Note:
After installed the filter, please open
the water valve to flush the filter for 5
minutes before use.
Water
The initial dark discoloration of
water is normal.
The water lines must be connected
potable water only.
with the
To operate properly, the ice maker
requires a water pressure of 207~689
Kpa.
Connect filter outlet line to the fridge
The outlet line of the water filter
should be connected with the inlet line
of the refrigerator by a Two-Way
Connector.
The water lines must be fully inserted
into the center of the connector to
prevent water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then
confirm that each clip holds the line
firmly.
Water line
Connector
Clip
Water line
10