Remote Controller - Mitsubishi Electric MSZ-LN18VG2W Notice D'utilisation

● OPERATING INSTRUCTIONS ●
P
REPARATION BEFORE OPERATION

Remote controller

Battery replacement indicator
Operation
display section
Temperature
buttons
Operation
select button
EN
ECONO COOL
button
POWERFUL
button
i-save button
NIGHT MODE
button
SENSOR
(i-see) button
CLOCK button
RESET button
TIME, TIMER set button
Change the time forward/backward
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
Press (forward) and
of timer.
WEEKLY TIMER set buttons
Press to enter the weekly timer setting mode.
Press and
Press , , and
perature.
Press to complete and transmit the weekly timer setting.
Press to turn the weekly timer ON. (
Press again to turn the weekly timer OFF. (
out.)
In the i-see control mode, the room temperature is con-
trolled based on the sensible temperature.
EN-4
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
OFF/ON (stop/operate)
button
FAN speed control
button
WIDE VANE button
VANE control button
PURIFIER button
DIRECTION
TIME, TIMER set
buttons
forward button
backward button
WEEKLY TIMER set
buttons
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
(backward) to set the time
to select setting day and number.
to set ON/OFF, time, and tem-
lights.)
OFF/ON (stop/operate) button
Operation select button
(AUTO)
Temperature buttons
Each press raises or lowers the temperature by 1°C.
FAN speed control button
(AUTO)
Left-right airfl ow control button
Up-down airfl ow control button
(AUTO)
DIRECTION button
(INDIRECT)
ECONO COOL button
The set temperature and the airfl ow direction are automati-
cally changed by the microprocessor.
i-save button
A simplifi ed set back function enables to recall the preferred
(preset) setting with a single push of the
the button again and you can go back to the previous set-
ting in an instance.
NIGHT MODE button
NIGHT MODE operation changes the brightness of the
operation indicator, disables the beep sound and limits the
noise level of the outdoor unit.
PURIFIER button
In the AIR PURIFYING operation, the indoor unit built-in
device reduces airborne fungi, viruses, mold, and allergens.
goes
POWERFUL button
(COOL) (DRY) (HEAT)
(Silent) (Low) (Med.) (High) (Super High)
(1) (2) (3) (4)
(DIRECT) (EVEN)
(FAN)
(SWING)
(5) (SWING)
(OFF)
button. Press