Craftmade Kira KR52 Instructions D'installation page 6

10
For blade assembly, position blade (7) through slot in fan motor housing
so that all screw holes are aligned (as shown in figure below). Position
light house assembly so that the top screw hole in blade lines up with
housing slot in flywheel. Using motor screws (S5), insert through blade
and into the fan motor. Tighten securely.
Light Assembly Housing
Housing Slot
Slot
Fan Motor
Blade
Remove rubber cushions, saving motor screws for blade installation. Using
motor screws (S5) provided, line up holes from the blade arm with the
holes in the motor housing. Tighten screws securely.
Step 10
Motor Flywheel
11
First install Halogen Bulb by screwing bulb into socket. Install Light Kit
Assembly by aligning slots on light kit to dimples on Light Assembly
Housing. Turn glass clockwise to lock securely in place.
NOTE: Hold fan motor housing while turning light kit/cover to ensure proper
installation.
CAUTION: Handle bulb using the protective bulb covering provided as
touching the glass with fingers will reduce the life of the bulb.
Fluorescent Bulb
Light Kit Assembly
Step 11
Light Assembly
Housing
Fluorescent Bulb