Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place top motor housing (4) over downrod assembly. Place
canopy (3) over downrod (2). Attach black antenna wire plug from top
motor housing to black antenna wire plug on motor housing. Make sure
connections are fully snapped together. Replace hanging ball, insert
hanging pin through downrod and tighten set screw "C" in hanging ball
into downrod.
Threaded Set
Screw Hole
Ground
Wire
Hanging
Pin
Ball
Hanging
Screw
Ball
Safety Bolt & Nut (S7)
WARNING: Failure to completely tighten downrod as described in steps 5 &
6 above could result in the fan loosening and possibly falling. IMPORTANT:
Black antenna wire must be connected for fan to function.
Step 6
Set Screw (C)
Downrod (2)
Canopy (3)
Top Motor Housing (4)
Set Screw (A)
Black Antenna Wire
Fan Motor Housing (5)
7
For added security, attach safety cable from fan unit to "J" hook (S8) in
outlet box. Secure by looping zip tie (S9) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for
click).
OUTLET BOX
Green Ground Wire
NOTE: Parts furnished will allow
you to install your fan at up to a
35° angle. Angles greater than
35° will require a 45° angle
adapter
(see dealer).
NOTE: J Hook installation is a
Canadian requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S8)
Outlet Box (A)
Ceiling
Mounting Bracket (#1)
"J" Hook (S8)
Zip Tie (S9)
Safety Cable
Publicité
Table des Matières
