Turning Square Corners - Singer HD0400S Instructions

Fold the fabric with the wrong sides together and
sew.
Press the pin tucks in the same direction.

Turning Square Corners

(1) Outside Corner
Cut out approximately 2 cm (51/64 inch) from the
corner, in line with the overedge seam edge.
Sew one stitch beyond point (A) and stop.
Raise needle and presser foot.
Pull the fabric to the rear of the machine just
enough to release the thread caught on the finger
of the throat plate.
Note: Presser foot has been removed to show
detail.
Turn the fabric and lower the presser foot so that
the knife is positioned in line with the cut edge.
Pull slack threads up, then start to sew.
(2) Inside Corner
Cut fabric at seam edge.
44
Cutting line
Cutting
line
Cut Slit