Eton ZoneGuard+ Manuel Du Propriétaire page 10

ZONEGUARD+ OWNER'S MANUAL
SELECT YOUR COUNTY
ZoneGuard+ lets you choose which alerts to receive—
SINGLE for one area; MULTIPLE for up to 25 areas; ALL for
everywhere...or in case you don't know your code.
1. With radio OFF, press <MENU>, then press <
> to select <COUNTY – ALL /SINGL/MULTI> mode.
<
2. Press <
or <
> to select.
ENTER YOUR CODE
Just a word of warning, you'll need to work kind of fast on
the instructions below. Sometimes the display will return to
the main menu and you'll have to start from the beginning.
For a SINGLE code:
1. With selected mode still flashing, press <
to begin.
2. Press <
or < > to adjust. Repeat for all other digits.
3. Press <MENU> twice to confirm and exit.
For MULTIPLE codes:
1. With selected mode still flashing, press <
make "01" flash. This is your first county/province code.
2. Press <
< > to adjust. Repeat for all other digits.
3. Press <
or < > to adjust to next county/province code. Press
< > or <
< > to adjust. Repeat for all other digits. Repeat for all
county/ province codes.
4. Press <MENU> twice to confirm and exit.
10
> or < >, when mode flashes, press <
> or < > to set first code digit. Press <
> or < > to set first code digit. Press <
> or < > to return to flashing "01", press <
> to set first code digit. Press <
> or
>
> or < >
>
> or < > to
> or
> or
>