Attaching The Drive Assembly For Bowl-Lift Mixers - KitchenAid KICA0WH Instructions

ASSEMBLING THE ICE CREAM MAKER CMD + SHIFT CLICK TO CHANGE COPY
Attaching the Ice Cr_eam Maker_ for_ Bowl-Lift Mixer_s
Locating
pins
Fit the freeze bowl into place over the
3
locating pins. Press down on the back of
the freeze bowl until the bowl pin snaps
into the spring latch.
Place the dasher inside the freeze bowl.
4
Attaching the dr_ive assembly for_ Bowl-Lift Mixer_s
Be sure the Stand Mixer is still OFF and
1
unplugged.
Pin too shor_t
NOTE: The freeze bowl is designed to fit all
bowl-lift mixers. If the bowl pin at the back
of the bowl is too short or too long to snap
into the spring latch, remove and rotate the
bowl so the opposite bowl pin faces the
spring latch. Repeat step 3.
Make sure the bowl-lift handle is still in
2
the down position, and the freeze bowl
and dasher are in place.
Cor_r_ect
pin fit
9