Dyna-Glo DGB390BNP Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Remove 2 preassembled M6x12 screws (AA) and
door handle sleeves (K) from the door handle (I).
Insert the 2 door sleeves (K) into the holes
located on the back of the door assembly (L),
insert the screws into the door handle
sleeves (K), through the door handle bezels (J)
and into the threaded holes in the door handle (I).
Tighten using Phillips screwdriver.
Hardware Used
M6x12 Screw
AA
Notes: (AA) hardware preassembled in
6. Insert the bottom hinge pin (labeled 2) of door
assembly (L) into the hole on bottom shelf (A).
Press the hinge pin (labeled 3) on the top
of the door assembly by hand and insert into
the hole (labeled 1) of upper front brace (H).
7. Carefully place the grill body (M) onto the cart
left side panel and cart right side panel (E & F).
Adjust the grill body (M) so that the holes in the
grill body (M) are aligned with the holes in the
tabs of the cart side panels (E & F).
NOTE: Make sure the gas hose is inside the
cart. Fasten the grill body (M) using 2 M6x12
screws (AA) and M6 plain washer (BB) on
each side.
Hardware Used
AA M6x12 Screw
M6 Plain Washer
BB
door handle
5
I
x 2
6
7
x 4
x 4
9
J
L
3
L
A
H 1
E
AA
BB
AA
K
2
M
F