Dyna-Glo DGB390BNP Mode D'emploi page 20

CARE AND MAINTENANCE
Burner Assembly
Removing The Burner Assembly
1. Make sure all control knobs are in the OFF
position, gas supply valve is closed, and the
gas hose is disconnected from the gas supply.
2. Open lid and remove warming rack, cooking
grates, and heat tents.
3. Remove hinge pin as illustrated in Figure 1. Remove the 2 screws that secure the igniter electrode
to the burner as illustrated in Figure 2.
Figure 1
Hinge pin
4. Slide burners out of firebox as shown.
Warming Rack
Cooking
Grates
Heat Tents
Figure 2
20
Screws