Dyna-Glo DGB390BNP Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 12.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
12. Place the heat tents (T) into firebox as
illustrated.
13. Place the cooking grates (S) into grill body (M)
as illustrated in the figure. Secure warming
rack (R) into grill body (M).
NOTE: Insert the warming rack (R) into the
four holes located on both sides of grill body.
14. Unscrew the igniter cap and insert AA
battery (B) into the igniter body with positive '+'
end facing out. Replace the igniter cap.
12
T
13
R
14
12
M
S
B