Trigger Operated; Power Adjustment Valve - Bostitch 200 Serie Manuel D'instructions Et D'entretien

MODEL IDENTIFICATION (Continued)

Trigger Operated:

The Trigger Operated model is cycled by actuation of the trigger.
The Trigger Operated tool will cycle each time the trigger is actuated.
Automatic:
The automatic model is cycled by actuation of the trigger. When the trigger is pulled lightly
with a short motion the tool will drive one fastener. When the trigger is pulled as far as
possible the tool will continuously drive fasteners automatically until the trigger is released.
The rate at which fasteners are driven in the automatic mode is adjustable. The speed
adjustment screw is located on the left side of the tool in the trigger valve area. Turning the
screw in a counter clockwise direction increases speed and in a clockwise direction
decreases speed. This model also includes a trigger free play adjustment to adjust the
amount of trigger stroke between single and automatic operation. Turning the adjustment
knob to the left increases the trigger travel from single actuation to automatic.
Speed Adjustment

POWER ADJUSTMENT VALVE

For Maximum Power: Rotate valve counterclockwise as far as possible.
To Reduce Power: Rotate valve clockwise for up to 30% reduction.
Trigger Free Play Adjustment
Power Adjustment Knob
-8-