Erreka BUL BL33 Guide Rapide D'installation Et Programmation page 11

Unlocking for manual operation:
1
• Insert the key (1) and turn until the cylinder (2)
protrudes a few millimetres.
• Turn the handle (3) 180º, until the cylinder coincides
with the $ symbol.
1
Mount the wall support.
Levels A and B are measured from the centre of the
hinge to the centre of the bracket orifice.
B
3
Position the gate support.
Bear in mind that the operator must be horizontal.
5
Install the opening stopper.
For inward opening: open the
gate manually and install the
operator opening stopper (see
figure).
For outward opening: install
the TA stoppers (see "elements
of the complete installation").
Unlocking
3
D187A
Assembly
A
P187A
P187C
Motorised operation locking:
1
• Turn the handle (1) 180º, until the cylinder coincides
with the % symbol.
• Insert the cylinder (2) by pushing and cover it (3).
2
Mount the operator on the wall support.
4
Mount the operator on the gate support, adjust the
swivel joint and position the protective cover.
3
D187B D187A
P187B
P187D
P187E
11