Parts Lists; Led Indicators; Using The Jump Starter - Facom B12.1C Notice D'instructions

3/ PARTS LISTS

AC charging socket
12V DC power outlet
Positive (+) battery
clamp and cable

4/ LED INDICATORS

Internal battery level:
Make sure the jump starter is not connected to a power source or a vehicle battery.
Press the Battery Status button.
• Red: Charge now
• Yellow: Charge soon
• Green: Ready for jump start
Charging status:
Connect the jump starter to a live power source.
• Blinking Yellow: Battery is charging
• Solid Green: Battery is fully charged
Charging percentage:
While the unit is charging, press the Battery Status
• Red: 1-49% charge
• Yellow: 50-89% charge
• Green: 90% or higher charge
5/ CHARGING THE JUMP STARTER, USING THE BUILT-IN CHARGER
- Charge immediately after purchase. Always keep your jump starter fully charged when it is not in use.
- Charge the jump starter indoors only.
- Work in a well-ventilated area and do not restrict the ventilation in any way.
WARNING! USE ONLY THE INCLUDED POWER CORD. USE OF AN IMPROPER
POWER CORD MAY RESULT IN A RISK OF FIRE AND ELECTRIC SHOCK.
- Connect the power cord to the AC charging socket on the side of the jump starter.
- Plug the power cord into a 120-240V AC electrical wall outlet.
- While the jump starter is charging, the yellow LED will blink.
- Complete charging may take up to 12 hours.
- When the yellow LED turns off and the green LED lights, the jump starter is ready to use.
- When the internal battery is fully charged, the internal charger will automatically go into maintain mode and maintain the
battery at full charge.
- Charge the jump starter as soon as possible after use.

6/ USING THE JUMP STARTER

Before using the jump starter, you must check that:
- The vehicle is wedged, the transmission is in neutral and the vehicle does not present any faults and is in good mechanical
condition.
- The operators are trained and know how to use the jump starter.
- The vehicle manufacturer's procedures are followed.
- The jump starter's charge level is sufficient.
6
Charging/battery status LEDs
button.
Cord/clamp holder
Fuse
Negative (-) battery
clamp and cable
Battery status button