Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Interrupting the scale-removal cycle
TOP model
Press the "Turkish bath" button; the time remaining before the
end of the function is shown.
Within 10 seconds, press and hold the "Turkish bath" but-
ton again, until the function is interrupted. The steam generator
draining and washing cycle then starts and the "Turkish bath"
button starts to flash again; when it switches off and the control
panel returns to stand-by mode, the cycle is complete.
TT model
Press and hold the "water-pitcher" button, until the function is
interrupted. The steam generator draining and washing cycle
then starts and the "water-pitcher" button starts to flash again;
when it switches off and the control panel returns to stand-by
mode, the cycle is complete.
~3"
Note:
For TT models, the scale-removal cycle cannot be interrupt-
ed if the waterfall or hydromassage jets are active.
1
3
All models
Note regarding counting the number of Turkish baths and interrupting the
scale-removal cycle
Depending on when you interrupt the scale-removal cycle, count-
ing of the number of Turkish baths is suspended, allowing you to
continue to use the function a certain number of times.
More specifically, for every hour of scale-removal cycle per-
formed, 3 more Turkish baths are made available before the system
requires the cycle to be performed again. In the same way, after two
hours 6 Turkish baths are made available, after three 9 are avail-
able, etc. When the scale-removal cycle is run to completion, the
total is reset and the full number of Turkish baths is available again.
Note that if the cycle is interrupted within the first hour (for
example after 59 minutes), the 3 additional Turkish baths are not
made available.
WARNING! Delaying activation of the scale-removal
cycle may seriously compromise the efficiency of the
steam generator and create potentially hazardous
situations. Jacuzzi strongly recommends running the
scale-removal cycle every time it is indicated.
Delaying activation of the scale-removal cycle
("manual release" function)
2
As an exception, the scale-removal cycle can be delayed and
the Turkish bath can continue to be used a certain number of times.
See the indications below.
~3"
WARNING! The scale-removal cycle contributes to en-
suring that the steam generator is perfectly efficient; it
is therefore recommended that the cycle be run every
time it is indicated (see "Turkish bath - Note regarding op-
eration of the Turkish bath and the scale-removal cycle").
TOP model
Press the "Turkish bath" button and then press and hold the ">"
button until you hear a beep (3).
~3"
62
2
beep
1
3
Publicité
Table des Matières
