Sequential" Program (Top Model); All Models - Jacuzzi frame Manuel D'utilisation Et Entretien

"Sequential" program (TOP model)

Press the "jet" key, the indicated configuration will appear on
the display. Use keys"<" or ">" to select the indicated symbol and
then press the "on/off" key.
2
3
The pairs of jets (represented by the four half-circles) are acti-
vated from the bottom upward; the sequence foresees that each
pair of jets remains active for 3 seconds and then passes to the
next one.
You can personalise the function by excluding one or two pairs of
jets so that the massage is concentrated in certain areas rather than
others.
Press the "on/off" key once the function has been activated
(when the arrow related to the jets is not displayed), it will stop and
the display will again show the initial screen (Shiatsu, cervical/
lumbar or sequential), from which another type of massage can
be selected.
The function lasts 15 minutes, but it can be interrupted (or
reactivated) at any time by pressing the "jet" key (the control
panel returns to the "awaiting instructions" mode) .
1
2
56
Jet deactivation
Pressing the keys "<" or ">", an arrow appears in correspond-
ence of the upper pair of jets; use the keys "<" or ">" to position
this arrow in correspondence of the pair to be deactivated and
then press the "on/off" key (on the display, the symbol related to
the deactivated jets is fully coloured, whereas the active jets are
only outlined).
1
2
A maximum of two pairs of jets can be excluded (the exclu-
sion does not cause a delay in the operating sequence).
To deactivate a third pair of jets, first one of the already excluded
jets must be selected, press the "on/off" key (the jets are reactivated)
and then exclude another pair, following the procedure indicated
above.

All models

If a few seconds pass without pressing any key, the control panel
will return to the "awaiting instructions" mode and then "stand-by":
press the "on/off" key to reactivate the control panel and then the
"jet" key to activate the desired program.
TT model
The scale-removal cycle cannot be interrupted if the hydromassage
jets are active.
1