Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"Cervical/lumbar" program
TOP model
Press the "jet" key, the indicated configuration will appear on the
display. Press the "<" or ">" key to select the indicated symbol
and then press the "on/off" key.
2
3
At this point, the following configuration will appear on the
display:
1
2
Use keys "<" or ">" to select the type of desired massage and
then press the "on/off" key to activate the function.
The symbol to the left represents the "cervical" massage (pairs
of upper jets), and the one to the right represents the "lumbar" mas-
sage (pair of lower jets).
By pressing the "on/off" key once the function has been ac-
tivated, it will stop and the display will again show the initial
screen (Shiatsu, cervical/lumbar or sequential), from which an-
other type of massage can be selected.
The function lasts 15 minutes, but it can be interrupted (or
reactivated) at any time by pressing the "jet" key (the control
panel returns to the "awaiting instructions" mode) .
1
2
1
54
Customising the program
(TOP models only)
Once the program is started, the speed with which the pairs
of jets are activated can be varied (this value is shown by the
horizontal bar located under the program symbol).
1 bar: the two pairs of jets are activated at the same time and oper-
ate continuously for the entire program.
2 bars: the two pairs of jets are activated 2 seconds from each other
(the sequence is repeated for the entire program).
This is the default value when the program is started.
3 bars: as above, only that the activation time for each pair of jets
is 1 second.
Refer to the following figures for a graphical representation of
the jet operation.
TT model
Press the indicated key: it will light up and also the upper LED
located next to it, (A), will turn on, meaning that the "cervical"
massage has been selected (pair of upper jets).
If the same key is pressed again within 3 seconds the lower
LED (B) will turn on, meaning that the "lumbar" massage has
been selected (pair of lower jets).
The jets operate as follows:
- the two pairs of jets are activated 2 seconds from each other (the
sequence is repeated for the entire program).
Refer to the central example in the following figures for a graphi-
cal representation of jet operation.
The function lasts 15 minutes, but it can be interrupted (or
reactivated) at any time by pressing the "jet" key (the control
panel returns to the "awaiting instructions" mode) .
(A)
(B)
Publicité
Table des Matières
