Alarms
When pressed, the key starts to flash and the alarm indicator
is immediately activated.
The symbol shown below appears on the display.
When the alarm is activated, the current function or functions
(except for those activated using the brassware and/or the scale
removal cycle) will be immediately interrupted; this will also oc-
cur if the shower unit is not connected to the alarm circuit.
If the Cromodream® function is activated, the light will turn
white.
To stop the alarm, press the key again (the display will switch
to the "awaiting instructions" mode).
The connection to the alarm circuit must be carried out at the
installation stage and in compliance with the warnings detailed in
the installation manual.
Waterfall (TOP/TT model)
T
he waterfall, which is a true massage for the shoulder area, is
located on the roof, above the panel that houses the brassware.
Make sure to have adjusted the water temperature and that
the control panel is in the "awaiting instructions" mode (refer
to chapters "Activating the electronic functions" and "Elec-
tronic activation of water jet functions").
Press the "waterfall" key, the water will exit from the opening
at the top (the display will show the following configuration):
TOP model
TT model
The function lasts 15 minutes, but can be interrupted (or re-
activated) at any moment by pressing the "waterfall" key.
TT model
The scale-removal cycle cannot be interrupted if the waterfall is active.
50