Troubleshooting - Atag VA8015NT Mode D'emploi

Troubleshooting

Type of fault on the display
F10 Overfilling water 1
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F52 Water level fault
F54 Overfilling water 2
F56 Circ. pump fault
Press any button to clear the error message.
Problem
The buttons do not react when pressed.
Cannot close door.
16
Action
Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the
service department.
See "Water remains in the dishwasher" in the table "Problem" below. If the problem persists, call
the service department.
Check that the water tap is on. Check that the outer filter on the inlet hose is not blocked. See
Unblocking the inlet hose filter in the chapter Care and cleaning. If the problem persists, call the
service department.
Turn off the water tap and call the service department.
Call the service department.
Turn off the water tap and call the service department.
Call the service department.
Possible causes
You have pressed the buttons too soon after
opening the door.
Child lock (button lock) activated.
The door is closed.
The buttons are dirty.
The baskets are not correctly positioned.
The door lock does not click into place and lock.
Action
Wait a moment then try again.
See the chapter Settings.
Open the door. The buttons only react to use
when the door is open.
Clean with a dry or slightly damp cloth.
Check that the baskets are correctly positioned
horizontally.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Check the door lock. If it does not click into place
and lock, open the door.
Press and hold the navigation button
the option button Auto Open
Then wait 30 seconds. Close the door. Check
that the door lock clicks into place and locks.
and
for five seconds.