Bissell PETHAIR ERASER 1650 Serie Mode D'emploi page 13

Cleaning & Replacing Top Pre-Motor Filters
1
Press Tank Release
Button and pull away
from vacuum.
3
Remove
pre-motor
filters from top
of dirt
container lid
by pulling out.
Cleaning & Replacing Bottom Post-Motor Filter
1
Press Tank
Release
Button
and pull
away from
vacuum.
3
Twist filter
counter-clockwise to
unlock and remove
from vacuum.
NOTE: Replace this filter every 3 to 6 months. Visit BISSELL.com for Model 1650 filter
replacements.
2
Pull tab out on
front of dirt
container and
pull handle up
to open filter
location.
24
h
2
With dirt container
removed, pull tab up to
access post-motor filter.
4
Both the Pre-Motor Mesh and
Foam filters are washable.
Clean with mild detergent,
rinse and squeeze all excess
water. Allow filters to dry
completely before reinserting.
Place dry pre-motor filters
back in the top of dirt
container placing the thick
foam filter last.
Lift to remove filter.
When reassembling, place
filter back in unit and twist
clockwise to "click" into place.
The pleated filter may NOT be
washed. If dust/debris
accumulates, gently tap the filter
on inside of a trash bin.
www.BISSELL.com
13