Operation - Bartscher MX 235 Plus Mode D'emploi

5.3 Operation

Control and inspections before start-up
Control / Inspection
Make sure that:
- there are no foreign
objects in the pot
Check the cleanness of:
- external parts of the
device
- surfaces of equipment
- internal parts of the
device (knife, disc, whip)
Check the condition of:
- permanent protective
- covers
- device body
Check the operational
condition of:
- steering /control/
protective parts
- control system.
Make sure that:
- there are no strange
noises after start-up
Procedure
Visual inspection in order to make sure that there
are no foreign objects in the pot, like tools, towels, etc.,
or any non-food products. Remove such objects if
found.
Before the operation of the device, all surfaces of
all mentioned parts must be inspected visually for their
cleanness.
In case of mould or other contamination clean the parts
according to section 6 "Cleaning and maintenance".
All permanent covers must fulfil their functions.
Perform the visual inspection of all mentioned parts
in order to make sure that their internal surfaces are not
damaged. After noticing the first symptoms of wear/
damage the parts must be immediately replaced. Contact
the customer service department or your dealer.
All systems must fulfil their designed functions.
Use the systems in such way that they operate in
the expected way.
The parts revealing the first symptoms of wear or damage
must be immediately replaced. Contact the customer
service department or your dealer.
In case of noticing any strange noises during the
inspection, indicating e.g. seizure or mechanical fractures,
turn the device off immediately and contact the customer
service department or your dealer.
- 41 -