Dyna-Glo DGO1890BDC-D Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
3. Attach door latch (K) to smoker body-left (G)
using two M4x10 screw (BB).
Hardware Used
BB M4 x 10mm
Screw
CAUTION: This unit is HEAVY! Do not attempt
4.
this step without assistance!
With the assistance of a helper, stand the unit
(Make sure that legs are attached). Position the
square smoke stack (A) with control arm to the
left as shown. Using 4 bolts (AA), attach square
smoke stack (A) to the top of smoker body (G).
Securely tighten with a Phillips screwdriver.
Reattach both doors.
Hardware Used
AA M6 x 12mm
Screw
5. Attach lifting handle (B) to smoker body-left (G)
using four M6x12 screw (AA).
Hardware Used
AA M6 x 12mm
Screw
x 2
x 4
x 4
7
3
BB
K
4
5
G
B
AA
G
AA
A
G