sunjoe TRJ13STE Manuel D'utilisation page 11

4. Rotate the whole unit 180 degrees. The tool is now ready
to be used in edger mode (Fig. 21).
Fig. 21
5. Use the edge of the guard as a guide when cutting near
fences and walls (Fig. 22).
Fig. 22
6. Move the edger in a backwards direction when trimming
around edges to avoid damage.
m
WARNING!
Do not trim near electrical wires.
Advancing Strings
NOTE: Your trimmer uses 0.063 in. (1.6 mm) diameter nylon
line to cut grass and weed quickly and easily. In time, the
tip of the nylon line will become worn and the auto-feed
mechanism will automatically feed and trim a fresh length of
line. The cutting line will wear faster if the cutting is done along
sidewalks or other abrasive surfaces or heavier weeds are
being cut.
The trimmer + edger is equipped with an auto-feed head.
Bumping the head to try to advance the string will damage
trimmer.
1. With the unit running, release the ON/OFF switch trigger.
2. Wait two seconds, and press the ON/OFF switch trigger.
NOTE: The strings will extend approximately 1/4 in. with each
stop and start of the switch trigger until the strings reach the
length of the safety guard.
3. Resume the trimming + edging.
m
WARNING!
Do not operate the grass trimmer + edger
in a tree, on a ladder, or on a scaffold; this is extremely
dangerous.
m
WARNING!
Do not bump the unit on ground in attempt
to feed line or for any other purpose.
Maintenance
m
WARNING!
Make sure to unplug your electric grass
trimmer + edger before inspecting its parts.
m
WARNING!
Always wear protective gloves during
maintenance tasks. Do not carry out maintenance when the
motor is running or hot.
• Your trimmer line can dry out over time. To keep your line in
top condition, store spare pre-wound spools or bulk line in
a plastic resealable bag with a tablespoon of water.
• Never use water or chemical cleaners to clean your grass
trimmer + edger. Wipe it clean with a dry cloth.
• Plastic parts may be cleaned by using mild soap and a
damp rag.
• Always store your grass trimmer + edger in a dry place.
Do not allow any liquid to get inside it.
• Keep the motor ventilation slots clean.
• If you see some sparks flashing in the ventilation slots,
this is normal and will not damage your power tool.
IMPORTANT! To ensure product safety and reliability, repairs,
maintenance, and adjustments to this power tool should be
performed only with identical replacement parts. Contact your
authorized Snow Joe + Sun Joe
®
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
11
dealer or call the Snow Joe
® ®