Bolt Torque Chart - Woods BRUSHBULL BB48XE Manuel D'utilisation

DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the Woods dealer. It should be
delivered to the owner completely assembled, lubricated, and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly will be easier if aligned
and loosely assembled before tightening hardware. Recommended torque val-
ues for hardware are located in the Bolt Torque Chart, page 36.
Complete Dealer Check Lists, page 22 when you have completed the assem-
bly.

Full chain, rubber, or steel band shielding must be installed when
operating in populated areas or other areas where thrown objects could
injure people or damage property.
• If this machine is not equipped with full chain, rubber, or steel
band shielding, operation must be stopped when anyone comes
within 300 feet (92 m).
1. Mounting pin hardware
2. A-Frame bar
3. Upper mounting hardware
(under clutch shield)
4. Diagonal brace
5A. Diagonal brace bar
mounting hole
5B. Tailwheel pivot hole
6. Tailwheel bracket
7. PTO Hanger
9. Tailwheel
10. Height adjustment
12. Bag of hardware
13. Driveline (Shear bolt)
14. Clutch shield
MAN1254 (3/16/2018)
ASSEMBLY
•
The mower deck and protective devices cannot prevent all objects
from escaping the blade enclosure in every mowing condition. It is
possible for objects to ricochet and escape, traveling as much as 300
feet (92 m).

Make sure spring-activated locking pin or collar slides freely and is
seated firmly in tractor PTO spline groove.

Always wear relatively tight and belted clothing to avoid getting
caught in moving parts. Wear sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing, and head; and respirator or
filter mask where appropriate.
9
7
1
Figure 29
. BB48XE Shipping Configuration
This shielding is designed to reduce the risk of thrown objects.
2
14
4
13
Assembly 23
6
3
10
5B
5A
DP4A