EAS ELECTRIC EMZ145W Guide D'utilisation page 19

CONTENTS:
Section 1. lnstallation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance
Section 1. lnstallation
 IMPORTANT! This appliance must be left to stand in an upright positi-
on for at least 4 hours before being switched on for the first time.
 This appliance has been designed for Domestic Use Only.
 Remove all packaging and securing tape from the appliance.
 Wash the interior of the appliance with luke warm water containing a
small amount of bicarbonate soda (5ml to 0.5 litres of water).
 Position the appliance in a dry atmosphere and out of direct sunlight.
 Do not position next to a cooker or other sources of heat, i.e. radiator.
 This appliance should not be sited in a cold atmosphere, i.e garage or
shed. Doing so may cause the freezer unit to underfreeze.
 lf positioned next to another fridge or freezer, leave a mínimum gap of
2cm between the appliances in arder to avoid condensation.
 A clearance of 50mm should be left above the appliance. lf this cannot
be achieved you should ensure a clearance of 25mm is maintained on
each side of the appliance.
 Fit the plastic wall spacers to the condenser on the rear of the applian-
ce, this will ensure an air gap between the appliance and the wall.
 Do not place or store heavy items on the top of this appliance.
 Ensure that the appliance is positioned on a firm flat floor.
 This appliance must be level. Adjust the level by screwing the adjusta-
ble feet up or down (use your fingers or a suitable spanner).
 Ensure that the appliance is upright and both feet are in firm contact
with the floor so that the cabinet is stable.
 Connect the plug to an adjacent 13amp socket out let and ensure that
the appliance is not standing on the supply cable.
6 V.2