Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
usER InstRuctIons
1. Any repairs to this appliance should be carried out by qualified/authorized service personnel only.
2. Under no circumstances should this appliance be modified. Parts having to be removed for servicing must be
replaced with original "OEM" (original equipment manufacturers) parts only.
3. This firebox is to be cleaned with a damp cloth (water) only. ImpoRtant: always unplug the power cord before
cleaning the unit. Do not use any abrasive cleaners on the unit.
4. Please unplug this firebox when not in use.
GRoundInG InstRuctIons
This heater is for use on 120 volts. The cord has a plug as shown in figure A in the
diagram. An adapter as shown in figure C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The green grounding lug extending
from the adapter must be connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a three-slot grounded
receptacle is available.
LocatInG YouR FIREpLacE
When choosing a location for your new fireplace, ensure the general instructions
are followed. Also, for best effect install the fireplace out of direct sunlight.
It is safe to set the fireplace insert close to non-combustibles. do not stoRE oR usE GasoLInE oR otHER
FLammaBLE VapoRs oR LIQuIds In tHE VIcInItY oF tHIs oR anY otHER appLIancE.
mantel Installation
Please refer to the detailed instructions that come with the mantel that you purchased.
attaching the firebox trims
Take your electric firebox out of its packaging and position it between the 2 legs of the mantel. Once you are close to the
wall, plug the firebox into the nearest outlet.
The firebox comes with 3 metal brackets and 16 black screws (15 required plus 1 spare). These metal brackets must be
attached to all 3 sides of the firebox and 2 sides of the mantel to ensure that your firebox does not move around as you
use it. All 3 trims attach to the firebox by inserting and tightening 3 screws. Both the left and right side trim attach to the
mantel front by inserting and tightening 3 screws
The top trim does not attach to the mantel, just the firebox.
spEcIFIcatIons
mFB28-2
Fireplace Insert
dimensions W x d x H
net Weight
Gross Weight
Voltage
Frequency
Watts / amps.
Heater Rating
All manuals and user guides at all-guides.com
27.2" x 9.7" x 23.1"
69.1 cm x 24.5 cm x 58.8 cm
37.4 lbs / 17 kg
44 lbs / 20 kg
120 V
60 Hz
1400 W / 11.6 A
4770 BTUs
2
Grounding Pin
Cover of Grounded Outlet Box
C
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
A
B
Publicité
Table des Matières
