Oceanic OCEAISHT1000W Guide D'utilisation page 25

Radiateur electrique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

attention has to be given where children and
vulnerable people are present.
 If the power cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
 The appliance should not be placed immediately
below a socket.
WARNINGS
overheating, do not cover the heater.
 Do not use this heater with a programmer, timer,
separate remote control system or any other
device that turns on the heater automatically
because there is a risk of fire if the device is
covered or placed incorrectly. Use only a remote
control device connected by the pilot cable.
 The device must be powered by a Residual
Current Device (RCD) with a rated operating
differential current of not more than 30 mA.
 Warning: if this appliance is installed in a
bathroom, it must be installed at least 60 cm
from a bath or shower (volume 2), in accordance
with the requirements of the French electrical
installation standard NFC 15 -100.
 The device must be connected to a circuit
independent electric protected by a bipolar
circuit breaker according to the standard
electrical installation NF C 15-100.
 With respect to the details of how to install the
appliance
"INSTALLATION" section.
onto
the
Page 25 of 43
: In
order
wall,
to
refer
to
avoid
the

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ht10tcgOceaisht1500wHt15tcgOceaisht2000wHt20tcg

Table des Matières