Videotec COMB Manuel D'instructions page 8

CAUTION!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
• Make sure the product is to be secured to building
before operation.
• Any change that is not expressly approved by the
manufacturer will invalidate the warranty.
• For technical services, consult only and exclusively
authorized technicians.
• Comply with all the national standards during the
device installation.
• The product can be installed in any position.
• All disconnected wires must be electrically
isolated.
• The manufacturer declines all liability for damage
to any of the apparatus mentioned in this
handbook, when resulting from tampering, use of
non-original spare parts, installation, maintenance
and repairs performed by non-authorised, non-
skilled personnel.
• This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be required
to take adequate measures.
6
• All cable glands, or other gadget of cable entry,
must be UL certified to maintain certification, in
any case adequate to the degree of tightness you
want to maintain.
• For damage to any parts, repair or replacement
must be done by, or under supervision of
VIDEOTEC.
• Whenever replacing the parts as indicated,
always use VIDEOTEC original spare parts and
meticulously follow the maintenance instructions
supplied with every spare parts kit.
• Use adequate personal protective equipment
during installation.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook. Improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or other
hazards.
• Connect the device to a power source
corresponding to the indications given on the
marking label. Before proceeding with installation
make sure that the power line is properly isolated.
MNVCCOMB_2131_EN