Drain Connection - Thermador DWHD650WFM Instructions D'installation

Drain Connection

IMPORTANT NOTES
•
If local ordinance require an air gap, install it according to
the manufacturer's instructions .
•
If the dishwasher drain hose is to be connected to a dis-
poser dishwasher drain connection, remove the plug from
the disposer's dishwasher drain connection .
•
The dishwasher drain hose must have one place along its
length that is securely attached 33" (508 mm) above the floor .
•
The drain hose length can be extended if necessary . The
maximum length of the drain hose, including the hose
leading to the air gap, is 150" (380 cm) .
19
•
You may use the piece you removed in Step 7 to attach to
the inside of the adjacent cabinet and hang the drain hose
from as shown (screws are not supplied) in place of using
a Nonmetallic Tie as pictured in the next illustrations . Do
not exceed 43" in drain hose height .
•
The dishwasher drain hose must be installed with a portion
of it at least 33" (84 cm) off the floor; otherwise the dish-
washer may not drain properly .
Note: Place hose clamp (C) around end of drain hose BEFORE
connecting to the plumbing .
16
about your drain connection:
20
a
B
•
The dishwasher drain hose may be connected to the drain
plumbing using an air gap in one of two ways:
- Connect to the under sink dishwasher drain connection (20a) .
- Connect to a disposer dishwasher drain connection (20b) .
c
B
•
The dishwasher drain hose may be connected to the drain
plumbing using a high loop in one of two ways:
- Connect to the under sink dishwasher drain connection (20c) .
- Connect to a disposer dishwasher drain connection (20d) .
21
B
B
•
Use the clamp provided (C) to
attach the drain hose to the
house plumbing as shown .
b
B
d