Greenlee EK425VX Mode D'emploi page 18

Model X—FCC ID: RFR-S50; IC ID:
4957A-S50
USA requirements:
Responsible party: Greenlee Tools, Inc.
Rockford, IL 61109 USA
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio com-
munications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case
the user will be required to correct the interference at
his own expense.
This device complies with the RF exposure SAR
test exclusion requirements for portable devices, if a
minimum separation distance is kept. However, the
device shall be used in such a manner that the potential
for human contact during normal operation is minimized.
Warranty
Model "VX" insulated tools are covered by the standard
Greenlee Limited Warranty for a period of 7 years, this
limited warranty excludes coverage for the Tri-Barrier
Insulation Collar and componentry.
The Tri-Barrier Insulation Collar and componentry are
covered by the standard Greenlee Limited Warranty for
a period of 2 years.
To review the standard Greenlee Limited Warranty, visit
www.greenlee.com.
Greenlee Tools, Inc.
Gator Insulated Battery-Powered In-Line Crimpers
®
18
Canada requirements:
This device complies with Industry Canada's license-
exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
1) l'appareil ne doit pas produire de brouillage;
2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est suscep-
tible d'en compromettre le fonctionnement.
For warranty claims and/or factory service please
contact Greenlee Customer Service by phone at
800-435-0786.
Shipping address:
Greenlee Factory Service Center
4411 Boeing Dr., Rockford, IL 61109
Reminder: Warranty claim is void if warranty seal on tool
is broken.
Do not perform any service or maintenance other
than as described in this manual. Personal injury or
damage to the tool may result.
The Tri-Barrier Insulating componentry must be
replaced by the factory every two years. Failure to
replace may result in personal injury or damage.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070