Publicité
Les langues disponibles
Les langues disponibles
• Read all of the Installation Manual that is included with the
DrawerMicro™ Oven before installing in the fl ush mount
confi guration.
• Observe all governing codes, ordinances, and safety instructions.
• Be sure to leave these instructions with the consumer.
1. Prepare cabinet opening as shown in Figures 1, 2A, 2B, 2C.
B
D
F
G
I
K
L
J
Figure 1
A
C L
Figure 2A
Top view
Suggested electrical
outlet location
Figure 2B
A
C
E
H
Note: the face of the shelf must
3
sit 1
/
"
(44.45 mm) back from
4
M
the face of the cabinet.
N
shelf face
O
cabinet face
Anti-Tip block
Mounting cleat
Drawer face
B
No oven
A
Anti-Tip block
B
C
Front view
Qty.
PREF-B019MRP0
Flush Mount
1
LX-CZB055MRE0
2
Mounting screws
A. 6" (152.40 mm)
B.
Suggested electrical outlet location
C. Anti-Tip block
D. 5" (127 mm)
E.
3-1/2" (88.90 mm)
F.
4" (101.60 mm)
G. 24-3/16" (614.35 mm) minimum
24-1/2" (622.3 mm) maximum
H. 14-13/16" (376.24 mm) to bottom of Anti-Tip block
I.
1-1/16" (26.97 mm)
J.
23-1/2" (596.90 mm) minimum depth
K. 22-1/8" (561.97 mm)
L.
1-3/4" (44.45 mm)
M. 16-7/8" (428.62 mm) opening
N. Floor must support 100 lb (45.4 kg)
O. 1-3/4" (44.45 mm)
A. 22" (558.8 mm) mounting cleat opening width
B. 1/4" (6.35 mm)
C. 1-1/16" (26.97 mm)
Cabinet
C
face
A. 22-1/8" (561.97 mm) mounting cleat opening width
B. 24-3/16" (614.35 mm) minimum
24-1/2" (622.3 mm) maximum fl ush opening width
C. 3/4" (19.05 mm) shelf
2
Parts Included
Publicité
