Control Knobs; Burner Grates And Components - Samsung NA30N6555T Serie Mode D'emploi

Care and cleaning of the cooktop

Control knobs

Make sure all surface burner knobs are in the OFF position.
01
02
01 Grasp each knob and pull straight
up to remove.
02 Spill protector. Do not remove.
20 English
NA30N6555TG_DG68-01089A-01_EN+MES+CFR.indb 20
1. Pull knobs off the control valve stems
2. Clean the knobs in warm, soapy water.
Then rinse and dry them thoroughly.
3. Clean the stainless steel surfaces using
stainless steel cleaner.
4. Re-attach the knobs in the OFF position
to the control valve stems.
CAUTION
• Do not clean the control knobs in a dish
washer.
• Do not spray cleansers directly onto
the control panel. Moisture entering the
electric circuits may cause electric shock
or product damage.

Burner grates and components

Turn off all surface burners and make sure they have all cooled down.
1. Remove the burner grates.
2. Remove the burner caps from the burner
3. Remove the burner heads from the
2
1
4. Clean all removable grates and burner
3
5. Rinse and dry grates and burner
6. Return the burner heads to their
7
8
See pages 22, 23, and 24 for detailed
6
burner component re-assembly instructions.
7. Return the burner caps to their positions
8. Re-install the burner grates in their
9. Turn on each burner and check if it
heads.
valve manifolds to reveal the starter
electrodes.
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
components thoroughly.
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.
NOTE
on top of the burner heads. To ensure
proper and safe operation, make sure the
burner caps lie flat on top of the burner
heads.
respective positions.
operates properly. After verifying that a
burner operates normally, turn it off.
5/28/2018 12:47:22 PM