Causes And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN CM1000 Mode D'emploi

17.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
Food is not sufficiently
defrosted, warmed up
or cooked after preset
time has elapsed.
The device functions
but the cooking
chamber lighting does
not work.
Abnormal noises can
be heard during
operation of
microwave.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
► If error messages continue to appear after an extended waiting period
and restarting the device, then the device will need to be sent to Customer
Service to be inspected.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials. However,
they also contain damaging substances, which were necessary for their functionality and
safety. If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not put your old
device into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Defective cooking chamber light.
Food is covered with aluminium
foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Attention
Please note
Please note
Action
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
51