Craftmade PV52 Mode D'emploi page 6

11
For blade assembly, position slot on fan motor housing so that you can
access the screws (as shown in figure below). Screw in the Glass Mounting
Screw and the Candelabra bulbs.
Blade Assembly
Candelabra Bulb
CAUTION: Handle bulb using the protective bulb covering provided as
touching the glass with fingers will reduce the life of the bulb.
Remove rubber cushions, saving motor screws for blade installation. Using
motor screws (S5) provided, line up holes from the blade arm with the
holes in the motor housing. Tighten screws securely.
Step 11
Glass Mounting Screw
Candelabra Bulb
Fan Housing
12
Attach Light Kit Assembly to the Fan Housing and secure using the Finial
(as shown below).
Nut
Step 12
Fan
Housing
Light Kit
Assembly
Glass
Mounting Screw
Finial