Luxury Whirlpool Bath
Operational Safety instructions
WARNING:
RISK OF HYPERTHERMIA AND POSSIBLE DROWNING!
Do not use a hydromassage bathtub equipped with a heater immediately following strenuous
exercise.
WARNING:
RISK OF ELECTRICAL SHOCK!
•
•
•
•
•
WARNING:
PROLONGED IMMERSION IN HOT WATER MAY INDUCE HYPERTHERMIA!
Hyperthermia occurs when the internal temperature of the body reaches a level several degrees
above the normal body temperature of 98.6°F (37°C). The symptoms of hyperthermia include an
increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting. The
effects of hyperthermia include:
A.
B.
C.
D.
E.
F.
WARNING:
RISK OF FETAL INJURY!
Pregnant or possibly pregnant women should consult a physician before using a hydromassage
bathtub equipped with a heater.
WARNING:
Keep body and hair a minimum of 6˝ (152mm) away from the suction fitting at all times when the
hydromassage system is in operation. Hair longer than shoulder length should be secured close
to the head.
WARNING:
The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia.
People using medications or having an adverse medical history should consult a physician before
using a hydromassage bathtub equipped with a heater.
WARNING:
Do not tamper with user-operated controls or such devices.
WARNING:
Use this unit only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturers.
WARNING:
To avoid injury, exercise caution when entering or exiting the hydromassage bathtub.
WARNING:
Do not use hydromassage bathtub unless all suction guards are installed to prevent body and
hair entrapment. Never operate the hydromassage bath if the suction cover is broken, damaged
or missing.
WARNING:
Water temperature in excess of 104°F (40°C) may be injurious to your health. Check and adjust
water temperature before use.
CAUTION:
Test the ground fault circuit interrupter protecting this appliance periodically in accordance with
manufacturer's instructions.
IMPORTANT:
Read the complete instructions provided in this manual before beginning installation.
IMPORTANT:
For optimal operation, the water level must remain at 1˝ to 2˝ (25mm to 50mm) above the highest
jet; do not use oil-based bathtub additives in your hydromassage bathtub.
The Company has obtained applicable code (standards) listings generally available on a national basis for products
of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation
of the product. The Company makes no representation or warranty regarding, and will not be responsible for any code
compliance. Product specifications are subject to change without notice.
Installation and Operation
Do not permit electrical appliances (such as a hair dryer, lamp, telephone, radio or television)
within 60˝ (1524mm) of this hydromassage bathtub.
Do not operate hydromassage system unless the bath is filled with water to at least 1-2˝
(25-51 mm) above the highest jet.
Do not immerse the control panel by overfilling the bath.
When cleaning your bath, do not use abrasive substances which will damage the bath's
surface.
To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of
140°F (60°C).
Failure to perceive heat.
Failure to recognize the need to exit the bath.
Unawareness of impending hazard.
Fetal damage in pregnant women.
Physical inability to exit the bath.
Unconsciousness resulting in danger of drowning.
www.jacuzzi.com
Page 5