Assembly Instructions - Dyna-Glo DGF493BNP Mode D'emploi

ASSEMBLY INSTRUCTIONS

1. Put two leg end caps (M) under left leg
assembly (L), and fasten them with two
ST4.8X10 screws (AA).
Hardware Used
AA
ST4.8x10 Screw
2. Slide the axle (T) through the right leg
assembly (S) and then put the wheels (U) on
both sides. Tighten the wheels with M10
nuts (BB) with M10-M6 wrenches (CC). Please
note, this step requires two people to
complete, and if necessary any other plier or
adjustable wrench can be used for assembly.
Hardware Used
BB
M10 Nut
CC
M10-M6 Wrench
1
M
x 2
2
S
x 2
x 2
7
L
AA
BB
T
U