Dyna-Glo DGF493BNP Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
11. Pre-assemble two M6x16 bolts (DD) onto the
grill body assembly (D) and do not tighten them.
Make sure to leave a 5mm gap between the
bolt and grill body's end cap. Then hang the
right side table assembly (R) on the bolts and
fasten the right side table assembly (R) with
three M6x16 bolts (DD) and tighten all bolts.
Hardware Used
DD
M6x16 Bolt
12. Assemble the fixing plate on the right leg
assembly (S) with two M4x10 bolts (II) and pay
attention to the direction of fixing plate, which
should be upward.
Hardware Used
II
M4x10 Bolt
11
x 5
12
x 2
II
12
DD
D
R
5mm
S