Main Technical Features - Eaton E5024C Serie Mode D'emploi

Main technical features:

Display: LCD, 8 decades, height of the figures 8 mm
[0.31 in.]
Display range:
-9999999 – 99999999 with leading zeros
suppression.
Overflow: In case of a display range overflow, the
counter starts again from 0, but without
removing the leading zeros and activating
all decimal points.
In case of a display range underflow, the
counter starts again from 0 and displays the
minus sign, without removing the leading
zeros and activating all decimal points.
Reset key: Requires rear terminal jumper to enable.
Housing: Panel mounting, 48 x 24 mm [1.89 x
0.94 in.] according to DIN 43 700, RAL 7021
Panel cut-out:
22.2 x 45 mm [0.87 x 1.77 in.]
22.5 x 45.6 mm [0.89 x 1.80 in.] max.
Mounting depth: approximately 48 mm [1.89 in.]
Weight: approximately 50 g [1.76 oz.]
Front panel rating: IP65
Input specification, pin assignment and adjustable operating modes (DC versions).
A control input (screw terminal 5) allows adjusting the operating mode.
Screw terminal No. 1
INP A
Designation
Model
E5024C0400 12 kHz
E5024C0410 7 kHz
Table 2
Screw terminals 1 and 2:
Function and max. frequences (50-50 duty cycle)
see Table 2
NPN : active for negative edge
Input resistance: approximately 1 MOhm
Low level: 0 – 0.7V DC
High level: 3 – 30V DC
2
No. 2
INP B
PNP 30 Hz NPN
NPN 7 kHz NPN
Connection:
Screw terminals, RM 5.00, 8 poles
Rated cross-section: 4.0 mm
Connection diameter:
EMC: Emissions per EN55011 Class B
Susceptibility per EN61000-6-2
Low Voltage Directive (for the AC/DC models):
EN 61010 Part 1 ; overvoltage category 2,
pollution level 2
Power supply:
Non-replaceable lithium battery
(lifetime approximately, 8 years at 20°C
[68°F])
Working temperature:
-10 to +55°C [14 to 131°F], relative humidity
< 85%, non-condensing
Operating temperature:
-10 to +60°C [14 to 140°F]
Storage temperature:
-20 to +70°C [-4 to 158°F]
Backlighting:
external electrical source
(24V DC ±20 %, 50 mA)
No. 3 No. 4
Reset Reset Control inputs for
Enable operating mode (Mode)
open =
adding
open =
Cnt.Dr
Mode
PNP :
Input resistance:
Low level:
High level:
2 solid wire
2.5 mm 2 stranded wire
AWG 12
0.4 – 2.3 mm
wire, AWG 28-12
No. 5 No. 6 No. 7 No. 8
GND
contact with
GND =
subtracting
contact with
GND =
Up.Dn Mode
active for positive edge
approximately. 100 kOhm
0 – 0.7V DC
4 – 30V DC
MN05401007E
2 solid
BL BL
– +