Makita UM600D Manuel D'instruction page 13

3. Adjust the three pins so that they are lined up on
the alignment line.
► 1 . Alignment line
4. Apply a small amount of grease to the periphery
of the crank. Attach the crank to the pins with the small
and large rounds facing down.
► 1 . Crank
5. Slide the shear blades so that the hole on the
base plate is positioned at the center of the rings of the
blades.
1
1
13 ENGLISH
6. Turn the shear blades upside down and install
them so that the pin on the tool fits in the hole on the
shear blades. Insert the claw of the base plate into the
groove on the tool. Make sure that the shear blades are
fixed securely in place.
► 1 . Claw
7.
Tighten the two screws firmly with a screwdriver.
1
► 1 . Screws
8. Place the undercover so that
cover is aligned with
1
on the under-
on the lock lever.