Service; Additional Safety Advice For Paint Spray Guns; Advice On Use; Din-Sec / Viscosity - Parkside PFS 100 B2 Instructions D'utilisation Et Consignes De Sécurité

General safety advice for electrical power tools / Advice on use
and advice. Electrical power tools are dan-
gerous when they are used by inexperienced
people.
e)
L ook after the device carefully. Check
that moving parts are working prop-
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam-
aged parts repaired before you use
the device. Many accidents have their origins
in poorly maintained electrical power tools.
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.

5. Service

a) Have your device repaired at the ser-
vice centre or by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
Additional safety advice
for paint spray guns
T he spray gun must never be used for
spraying inflammable substances.
Spray guns must never be cleaned
using inflammable solvents.
I f you do not know the level of danger
a substance presents, do not spray it.
P recise observation of the hazard
warnings, information and data
sheets available from the sprayed
medium manufacturer is essential.
Wear a breathing / dust mask!
The inhalation of paint mist and sol-
vent vapour is hazardous to health.
W ork in adequately ventilated
spaces only.
Wear protective glasses!
N ever aim the spray at living
creatures.
DANGER OF ExPLOSION! Do
not use the device in environments
containing gases, open flames, fires
or gas-operated water heaters.
NO SMOKING!
P aint and solvents (thinners) must
have a flashpoint above 21°C.

Advice on use

Q

DIN-sec / Viscosity

Q
The Parkside paint spray gun PFS 100 B2 can be
used to apply sprayed media with a viscosity up to
80 DIN-sec. Viscosity is determined in a simplified
measuring procedure using the supplied measuring
cup (see Fig. C).
1. Immerse and fill the supplied measuring cup
to the top with the medium to be sprayed.
2. Lift the measuring cup
to be sprayed and let the liquid flow out (see
Figure C).
3. Measure the time in seconds it takes for the
flow of liquid out of the measuring cup to cease.
This time is the "DIN-seconds (DIN-s)" value of
viscosity.
4. If the value is too high, incrementally add and
mix in small quantities of a thinner compatible
with the medium to be sprayed. Proceed in ac-
cordance with the section about "Preparing the
sprayed medium".
12
out of the medium
12
GB 29