Moehlenhoff BSF 20102-04 Manuel D'instructions page 42

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
No. Parameters
010 Used heating system
020 Heating/cooling block
030 Operation lock
(child safety lock)
031 Operating lock password
040 External sensor connected
to the RBG
060 Correction of actual value
registration
110 Control direction
switching outputs
115 Use as setback input
120 Unit of temperature
display
Pump configuration
130 Pump output
131 Pump type
132 Pump turn-on delay
133 Pump follow-up time
Description
Adjustable per heating zone: Floor heating (FBH)
standard / FBH low energy / radiator / convector
passive / convector active
Blocking the switching outputs depending on the
activated operating mode (heating/cooling)
Unlocking the operating lock with password protec-
tion
Determine PIN if parameter 30 is set to active
Logging on an additional sensor for the registration
of the floor temperature (Floor sensor), the room
temperature or the dew point
Registration of the actual temperature with a correc-
tion factor
Switchover of NC and NO actuators (only globally)
Change-over between use of the ECO input for
setback or holiday function of the room control unit.
The holiday function cannot be activated any longer
via the room control unit if this parameter has been
set to 1.
Toggle function of the display between degree
Celsius and degree Fahrenheit
Use the control of a local recirculation pump (in the
heating circuit distributor) or a global recirculation
pump (heating installation).
Selection of the used pump: Conventional Pump
(KP) / High efficiency Pump (HP)
Time elapsing from the moment of the command
from a switching output until the pump is actually
switched on.
Time elapsing from the moment of switching off
the switching outputs until the pump is actually
switched off.
Unit
FBH St.=0
FBH NE=1
RAD=2
KON pas.=3
KON act.=4
Standard: 0
normal=0
Heating block=1
Cooling block=2
Standard: 0
Deactivated=0
Activated=1
Standard: 0
0000..9999
no sensor=0
Dew point sen.=1
Floor sensor=2
Room sensor=3
Standard: 0
-2.0...+2.0 K
in 0.1 increments
NC=0 / NO=1
Standard: 0
ECO=0
Holiday=1
Standard: 0
°C=0
°F=1
Standard: 0
local=0
global=1
Standard: 0
CP=0
HP=1
Standard: 0
[min]
Standard: 2
[min]
Standard: 2
41
DEU
ENG
FRA
NDL
ITA
ESP

Publicité

Table des Matières
loading

Table des Matières