GOLDONI 30HST TS24 Emploi Et Entretien page 84

set and stay there as long as the draft is less than that set.
- S: allows draft to be set to tractor slip limit at a position set by the controlled
position operation. After regulating the work position as described above,
regulated the draft by turning potentiometer S until the implement reaches
the required position but always within the tractor's ground holding potential.
Turn towards (+) plus, draft decreases by limiting working depth. Turn it
towards (-) minus, draft increases and work depth is increased. After
regulating draft, operate the lift with lever A. When the implement lowers, it
will be positioned for the draft set.
- A:
Position 0 - Lever in middle position. The lift is in neutral. The implement will
hold at its current position.
Position 1 - Lever lowered. The implement will lower to the draft setting given
and until the draft exceeds the level set.
Position 2 - Lever raised. The implement will be raised as long as the lever is
held upwards. When the maximum height is reached, a limit switch stops lift
raise. When the lever is released, it will automatically reset to position "0"
(neutral).
4.9.1.5 Lift safety lock
When the tractor is being transported, shut off the hydraulic lift delivery line but
turning the fluid volume regulator n.26 fig.1 all the way clockwise.
Summary of controls
Raise - lower
• Lift control
• Speed regulation
Controlled position
• Lift control
• Regulation
Controlled draft
• Lift control
• Draft regulation
• Sensitivity regulation
Mixed
• Lift control
• Regulation
Lift lock
• Regulation
Lever A
Knob n.26 fig.1
Lever A
Potentiometer P
Lever A
Potentiometer S
Knob n.26 fig.1
Lever A
Potentiometer P
Potentiometer S
Knob n.26 fig.1
83