NSK Variosurg3 Mode D'emploi page 20

Water does not exit, or flow
level is low.
Irrigation leak.
Irrigation does not stop.
Handpiece LED does not
illuminate.
LCD display does not properly
display.
Part of display is missing.
Settings are not memorized
Wrong settings are
memorized.
* Repairs cannot be made by the customer.
Foot Control is not connected.
Irrigation Tube is not connected to Irrigation
pack or Handpiece.
Irrigation Tube is not properly mounted to
the pump.
The Pump Cover is open.
The Irrigation Tube is broken (leaking).
Leak from the connection between
Irrigation pack and Irrigation Tube.
Leak from the connection between
Handpiece and Irrigation Tube.
Leak from Irrigation Tube.
Mode is set to Auto Cleaning.
Faulty circuit.
LED is burned out.
Failure inside the Control Unit or inside the
Handpiece Cord.
Failure or disconnection of the circuit.
Overheating.
Error Code is displayed.
Failure of the LCD display or driving circuit. Turn the Main Power OFF and then ON. If
Figures have been temporarily changed.
Foot control is being operated.
An Error Code is displayed.
19
Check the connection.
Check the connection.
Check the connection.
Close the cover.
Replace the Irrigation Tube.
Insert Irrigation Tube Needle all the way
into the Irrigation pack.
Insert the end of the Irrigation Tube
completely into the Handpiece water pipe.
Replace the Irrigation Tube.
To stop irrigation, press the Flow key.
Service only by Authorized NSK Dealer.*
Service only by Authorized NSK Dealer.*
Service only by Authorized NSK Dealer.*
Service only by Authorized NSK Dealer.*
Heat can cause LCD display malfunction.
Turn the Main Power OFF to cool down.
Refer to the Error Code table.
part of initial display is still missing
Contact your Authorized NSK Dealer.
Increase or decrease the Program No. by
one, and then return to the original setting.
Settings cannot be saved while LED
Handpiece with cord is operating.
Refer to the Error Code table.