Storage And Service - Tripp-Lite AVR Serie Manuel Du Propriétaire

Basic Operation
Battery Replacement Door (bottom panel, not shown; select models only):
Under normal conditions, the original battery in your UPS will last several years.
Battery replacement should be performed only by qualified service personnel.
Refer to "Battery Warnings" in the Safety Section. Should your UPS require battery
replacement, visit Tripp Lite on the web at www.tripplite.com/support/battery/index.
cfm to locate the specific replacement battery for your UPS.
Automatic Voltage Regulation (internal, not shown; select models only):
Automatically adjusts fluctuations to incoming voltage (under/over voltages) to
supply connected equipment with 120V computer-grade output power. Automatic
voltage regulation functions separately from battery power (will not drain battery).

Storage and Service

Storage
To avoid battery drain, all connected equipment should be turned off and disconnected from the
UPS. Press and hold the ON/OFF/TEST switch for one second. Your UPS will be completely turned off
(deactivated), and will be ready for storage. If you plan on storing your UPS for an extended period,
fully recharge the UPS batteries every three months. Plug the UPS into a live AC outlet, turn it on by
pressing and holding the ON/OFF/TEST switch for one second, and allow the batteries to recharge
for 4 to 6 hours. If you leave your UPS batteries discharged for a long period of time, they will suffer a
permanent loss of capacity.
Service
A variety of Extended Warranty and On-Site Service Programs are also available from Tripp Lite. For
more information on service, visit www.tripplite.com/support. Before returning your product for
service, follow these steps:
1. Review the installation and operation procedures in this manual to insure that the service problem
does not originate from a misreading of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit www.
tripplite.com/support.
3. If the problem requires service, visit www.tripplite.com/support and click the Product Returns link.
From here you can request a Returned Material Authorization (RMA) number, which is required for
service. This simple on-line form will ask for your unit's model and serial numbers, along with other
general purchaser information. The RMA number, along with shipping instructions will be emailed
to you. Any damages (direct, indirect, special or consequential) to the product incurred during
shipment to Tripp Lite or an authorized Tripp Lite service center is not covered under warranty.
Products shipped to Tripp Lite or an authorized Tripp Lite service center must have transportation
charges prepaid. Mark the RMA number on the outside of the package. If the product is within its
warranty period, enclose a copy of your sales receipt. Return the product for service using an insured
carrier to the address given to you when you request the RMA.
201002196 93-2974.indb 5
continued
5
3/10/2010 10:46:17 AM