Binding; Range-Checking The Radio System - Horizon Hobby Axial Bomber Fabrication RR10 BOMBER Mode D'emploi

EN

BINDING

Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter. The
SPM2340 transmitter and SR315 receiver are bound from the factory. If you
need to rebind, follow the instructions below.
1. Connect a fully charged battery pack to the ESC.
2. Center ST Trim and TH TRIM dials on the transmitter.
3. Power on the ESC.
4. Press the button on the SR315 to start bind mode. LED on SR315 will
flash.
5. While holding Bind button on the Transmitter, press Power Button to
power on the Transmitter. Release bind button when LED on SR315
stops flashing.
6. Vehicle is ready to operate.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle or steering
reversing has been changed.
• Binding the receiver to a different transmitter.

RANGE-CHECKING THE RADIO SYSTEM

The radio system should be checked before operating the vehicle to ensure proper operation and adequate range.
1. Turn on the transmitter.
2. Connect the battery in the vehicle.
3. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
4. Walk away until you are at the maximum planned operating distance from the vehicle.
5. Turn the steering wheel side to side and operate the throttle, both forward and reverse, checking for any erratic behavior.
6. If any erratic behavior is exhibited, DO NOT operate the vehicle. Call customer service for assistance.
8