BGS technic 6794 Mode D'emploi page 3

Pistol-Grip Air Inflator, digital, 0 - 8 bar
TECHNISCHE DATEN
Max. pressure: 8 Bar
Measuring range (psi): 0.0 – 58.0 psi
Measuring range (bar): 0.00 – 4.00 bar
Measuring range (MPa): 0.000 – 0.400 MPa
Measuring range (kg/cm²): 0.00 – 4.00 kg/cm²
Battery: 3V CR2032 (2 piece)
Pressure gauge: Ø 59 mm
Display size: 26 x 13 mm
ATTENTION
Read and understand all instructions and information in this manual. Failure to follow the instructions and
information below may cause serious injury and damage. Keep the manual for future reference in a safe
and dry place.
INTENDED USE
This pistol-grip air inflator is used for the checking the air pressure and filling tires with car tire valve
(Schrader valve).
SAFETY INSTRUCTIONS
•
Operate the pistol-grip air inflator only for the purpose, for which it is intended.
•
Make sure that the trigger of pistol-grip air inflator is in the OFF position before connected to the air
system.
•
Only use accessories which are designed to use with air tools.
•
Disconnect the pistol-grip air inflator from the air supply before installing accessories, performing
maintenance, or when not in use.
•
Always use the pistol-grip air inflator with common sense.
•
Operate the air tool only on air systems that do not exceed the maximum permissible pressure of
this pistol-grip air inflator.
•
Never point the air jet to people.
•
Observe the manufacturer's instructions for the air system when installing pressure regulators,
filters and other accessories.
•
Keep children and other unauthorized persons away from the work area.
•
Do not allow children to play with the air tool or its packaging.
OPERATION
1. Press the "ON" button (1) to switch on the device, the
display backlight lit up and a pressure value of 0 is
displayed.
2. Press the "FUNC" button (2) to select the desired unit.
The following units are available:
PSI / Bar / MPA / kg / cm²
3. Connect the test hose (3) to the tire valve.
4. The current pressure in selected unit appears on the
display.
5. Press the trigger (4) to increase or the release valve
(5) to reduce the air pressure.
6. Finally, press the "ON" button (1) again to switch off
the device.
Note: The backlight turns off automatically after approx. 1
minute and can be reactivated with the "FUNC" button.
The device itself switches off automatically after approx.
2.5 minutes.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6794
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed