Safety Advice - BGS technic 9255 Mode D'emploi

SPECIFICATIONS
Rated load: 3000 kg
Lifting height: 130 - 465 mm
Lifting height (rated load): 315 - 465 mm
Overall dimension (lowest position): 572 x 328 x 175 mm
Front wheel dimensions: Ø 66 x 40 mm
Rear wheel dimensions: Ø 60 x 30 mm
Lever total dimensions: Ø 32 x 1013 mm
Lifting pad diameter: 110 mm
Lifting beam thickness: 4,5 mm
Net weight: 27.4 kg

SAFETY ADVICE

• Read, study, and understand all warnings and operating instructions prior to use
• Do not overload this jack beyond the rated capacity.
• This jack is designed for use only on hard level surfaces capable of sustaining the load. Use on
other than hard level surfaces can result in jack instability and possible loss of load.
• This is a lifting device only. immediately after lifting, support the vehicle with jack stands
• Do not get under or allow anyone under the vehicle, until it has been supported by jack stands.
• Do not move or dolly the vehicle while on the jack.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Center load on saddle prior to lifting.
• No alterations to the jack shall be made.
• Failure to heed these warnings may result in personal injury and / or property damage.
• Inspect before each use. Because of the potential hazards associated with the misues of
equipment of this type, no alterations shall be made to the product without written authorization
of the manufacturer or supplier.
OPERATION
•
The owner and/or operator is responsible for providing maintenance, maintaining all decals or
warning labels and while in use, maintaining the unit in good work order.
•
Read all warnings and instructions. Make sure that the operator comprehends its contents. Safety
information shall be emphasized and understood prior to usage.
•
The jack shall be inspected per the instruction manual prior to use. It is the owner and/or
operators responsibility to study all WARNINGS, operating, and maintenance instructions
contained on the product label and instruction manual prior to operation of this unit, The
owner/operators shall retain product instructions for future reference.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Hydraulic Floor Jack 3.0 T
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9255
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed