Control Panel; Pin And Puk Code; Start-Up - AL-KO Robolinho 4000 Mode D'emploi

en

CONTROL PANEL

Control panel
3-1 The [LCD display] displays the current status or the selected menu.
Pressing the [STOP key] stops the Robolinho and the cutting blades within 2 se-
3-2
conds.
The [up and down arrow keys] are used for navigating in the menu and for chan-
3-3
ging values.
Press the [START/PAUSE key] to start the Robolinho or interrupt operation. Cau-
3-4
tion – The machine starts automatically after about 2 minutes!
[Multifunction key right]
Confirm (call up a menu, confirm a change of values)
Next
3-5
Change
Activate / deactivate
Store / confirm
[Multifunction key left]
3-6 Cancel
Back (close menu, when entering values, go one value back)
3-7 The [ON/OFF key] is used for switching the Robolinho on or off.
The [menu key] can be used for jumping back to the main menu from any sub-
3-8
menu.
The [HOME key] cancels the current mowing procedure. The Robolinho moves to
3-9 its base station. The Robolinho starts on the next day, with the next mowing win-
dow.

PIN AND PUK CODE

Keep the PIN code and PUK code where they
cannot be accessed by unauthorised people.
The PIN code can be changed by the owner.
The PUK code can be stored by registering
on the following website:
http://robolinho.al-ko.com
If the PIN code is entered incorrectly three ti-
mes, it will be necessary to enter a PUK code.
If an incorrect PUK code is entered several
times, it is necessary to wait 24 hours before
a new entry can be made.

START-UP

CAUTION!
Before using the Robolinho for the first
time, put the unit into the charging de-
vice, to charge the battery!
30
Preparation
Before starting to operate the Robolinho, place it
in its starting position in the defined mowing area
(12-3).
Comply with the specified dimensions.
Switching on
AL-KO Robolinho
Robolinho 4000 model
Software # xxxxxx
Serial number xxxxxx
Status display
1 Switch on the Robolinho by pressing the [ON/
OFF key] (3-7).
The LCD display (3-1) then shows the il-
lustrated information.
Control panel
Robolinho 4000
©