Filling The Coffee Maker With Water For Brewing - KitchenAid KCM1208 Mode D'emploi

USING THE COFFEE MAKER

FILLING THE COFFEE MAKER WITH WATER FOR BREWING

TIP: Brew 2 pots of fresh, cool water and discard before brewing the first pot of coffee.
1
1
Make sure to fill the water tank with only the amount of water needed to
IMPORTANT:
brew your desired number of cups. If you put in 12 cups of water, the Coffee Maker will
brew all 12 cups.
2
ASSEMBLY AND USAGE OF BREW BASKET
1
2
IMPORTANT: Do not use both types of filters at the same time.
Using both filters might cause water and coffee to overflow the brew basket.
Remove the water tank lid and pour with enough fresh,
cool water to make the desired amount of coffee. Use
the level markings on the water tank window. Close
the water tank lid properly.
OR
Remove the water tank lid and then lift the water tank
up gently using handle. Pour enough fresh, cool water
to make the desired amount of coffee. Place the water
tank back in position. Use the alignment feature on the
water tank to make sure the water tank is properly in
place.
Place the carafe in the Coffee Maker. Make sure the lid
is securely in position and bottom of the carafe is fully
seated; otherwise, the Pause and pour feature may
not engage, causing water and coffee to overflow the
brew basket.
Raise the brew basket lid and remove the brew basket.
Insert the Gold Tone permanent filter or cone paper
filter into the brew basket.
TIP: The coffee filter can also be inserted and coffee
grounds added with or without removing the brew
basket from the Coffee Maker.
USING THE COFFEE MAKER | 7